SaabCentral Forums banner
1 - 3 of 3 Posts

·
Registered
Joined
·
1,655 Posts
Discussion Starter · #1 ·
I replaced my rear regulator and didnt have proper size rivets, so i just temporarily ziptied it to door frame...Problem is now window isnt going all the way up theres a small gap which i think is because of it not being perfectly aligned... Anyone know the rivet size or even what size bolt or screw i can use... Thanks guys
 

·
Registered
Joined
·
21,583 Posts
Probably 3/16 or 6 mm, around that size; if you drill them out, and use a screw, be careful, the clearances here may be tight.
Use a locking nut, or a nylock.
Good luck:cheesy:
 

·
Registered
Joined
·
1,655 Posts
Discussion Starter · #3 ·
Thanks EW, helpful as usual
Probably 3/16 or 6 mm, around that size; if you drill them out, and use a screw, be careful, the clearances here may be tight.
Use a locking nut, or a nylock.
Good luck:cheesy:
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top