Got it figured out after looking at the EPC diagram. The mounting bracket bolts are to the exterior of the case only. After removing them I still didn’t have enough room to coax it out of the way to get the mount out of the fender so I undid the forward torque arm (it was getting replaced next) and that allowed it to drop just enough.
![Motor vehicle Automotive tire Bumper Automotive exterior Automotive wheel system]()
![Automotive fuel system Motor vehicle Gas Coil Automotive tire]()
Photos included to show how to coax it out for everyone else. In the second photo you can see the bracket to the trans slid forward and down out of the way.
Photos included to show how to coax it out for everyone else. In the second photo you can see the bracket to the trans slid forward and down out of the way.
