SaabCentral Forums banner
1 - 4 of 4 Posts

·
Registered
Joined
·
1,266 Posts
Discussion Starter · #1 ·
Does this look correct for RH? The markings for lh and rh match the pieces but the motor hangs up trying to open the glass. Vent works but as it closes the slides move about 5-6mm backwards causing it to hang. If I push the glass down it still will not retract the glass.

278532


Not sure how it managed to get in that position on its own. Is there a pic of a proper vent position somewhere? The manual has potato-cam images in it.
278533
 

·
Registered
Joined
·
1,266 Posts
Discussion Starter · #2 ·
I'm still fighting with these. They will not retract, only vent and partially close.
 

·
Registered
Joined
·
1,266 Posts
Discussion Starter · #3 ·
Ok.. guess I'm on my own on this one. I'll post back once I figure it out.
 

·
Registered
Joined
·
1,266 Posts
Discussion Starter · #4 ·
Proper orientation. There is an L and R on the respective locking plates. If the rear of the glass is too low or too high it will hang on retraction.

Bumper Wood Gas Machine Auto part
 
1 - 4 of 4 Posts
Top