SaabCentral Forums banner

1 - 4 of 4 Posts

·
Registered
Joined
·
17,665 Posts
Discussion Starter #1 (Edited)
Photo below of where my passenger side axle enters the tranny. Should there be a dust cap here? It looks kind of naked there.

Looking at the EPC diagram (also below), it looks like seal #26 perhaps should be down there? Or is that up against the carrier bearing end of the axle i.e. #21? I do have one at the other end (bottom photo).

272193


272192


Other End At Carrier

272196
 

·
Registered
Joined
·
9,601 Posts
That's how they all look. There's no dust cover on the transmission end, just on the intermediate shaft bearing, like you have pictured. Even though that seal has holes in the metal shield, it's all sealed up on the inside, and nothing can get in.
 

·
Registered
Joined
·
17,665 Posts
Discussion Starter #3
OK, thanks, thought something got left out when it was reinstalled. I've never pulled further than the companion shaft/tripod.
 
1 - 4 of 4 Posts
Top