Joined
·
115 Posts
Almost finished putting my engine back together and I’m having trouble locating where this part goes. I think it hold a wiring loom in place somewhere. Any ideas?
Recognize this part?
1 - 4 of 4 Posts
Joined
·
7,414 Posts
I've torn a few B235's apart and don't recognize that part. Clearly something from the outside but I can't place it.
Joined
·
115 Posts
Figured it out! It's the bracket that holds the oil cooler hoses to the body, behind the air filter box. Talk about obscure.
Joined
·
495 Posts
bracket that covers oil lines to subframe. I found didn't need.
BEAT me to it!
BEAT me to it!
1 - 4 of 4 Posts
Join the discussion
Recommended Reading
-
Heater blows cold intermittently + possible cooling issue
9-5 WorkshopThe heat blows hot sometimes but often blows cold. When it's blowing cold the right tube leading to core is hot but the left is luke warm. In the recent past I have replaced the head gasket, water pump, thermostat, heater core, and about 3 years ago the coolant bypass valve. When it's blowing...- 1
- 54
-
ilikebass18 · updated
-
Which way does check valve (Pre-2004) between TB and valve cover go?
9-5 Workshopstill trying to figure out my vacuum leak and questioning if I did this right when I put the engine back in. Arrow toward throttle body, right?- 6
- 67
-
unclemiltie · updated
-
Confused, please help - replacement alternator won't fit in to bottom bracket
9-5 WorkshopI'm replacing the alternator in my mother's car and I've gotten the hard stuff out of the way - old one out, new one in place, but for some reason the replacement alternator won't fit in to the bottom 'bracket' (not the upper removable bracket) Sorry for the poor quality picture. This is...- 11
- 87
-
9-5 Heel to NO
9-5 WorkshopAnybody notice that it is next to impossible to heel to toe without mashing the brake first? Firstly, my foot barely can fit when attempting this maneuver. Second, the gas pedal is so far forward in relation to the brake that I can’t even get my ankle to bend at such an acute angle. I have owned...- 2
- 39
-
1HOTAero · updated
-
P0300, P1300 and P0455 after engine removal/replacement
9-5 WorkshopOk, so the oil leak is now gone but I'm getting a rough idle and throwing the above codes since I put the engine back into my 9-5 Aero. Random mis-fires and evap leak. I can't find what is causing this. The car runs great above idle but at idle it is clearly missing and stumbling. Everything...- 4
- 104
-
unclemiltie · updated
Join now to ask and comment!