SaabCentral Forums banner

1 - 6 of 6 Posts

·
Registered
Joined
·
239 Posts
Discussion Starter #1
Is there some kind of trick to get the rear oil seal out behind the flywheel...I've searched for an answer on here...but cant seem to find one...I've got a seal puller, but i'm really afraid I'm gonna bang up the metal casing holding the seal in.:eek:

Any advice is appreciated....as I'm currently stuck until I can figure out how to get it out.
 

·
Registered
Joined
·
239 Posts
Discussion Starter #3
That's what I would usually do...but I can get a grip on it with my puller...I was thinking I could drill a pilot hole in the seal and put a screw in it and pull it out
 

·
Registered
Joined
·
4,388 Posts
That was going to be my next sugestion, just don't let any swarf go into the hole. Grease on the bit may help.
 

·
Registered
Joined
·
4,388 Posts
When I need to make a seal driver and can't find what i'm looking for in the steel rack at work I head off to the local hardware store with my seal and tape measure. I usually head for the plumbing department, but have found seal drivers in the kitchen-ware dept. too ( it was a small metal mixing bowl that time, perfect):cheesy: .
 
1 - 6 of 6 Posts
Top