SaabCentral Forums banner
Cancel

oh oh, what have i done, clutch slave

634 Views 3 Replies 3 Participants Last post by  cromero, 
C
i just installed the new clutch kit and just after i finisned bleeding the slave. i clutched two times to verify slave working. the clutch felt good and all worked fine. all i needed to do was remove the tine spacer. had the wife press in on clutch while i removed spacer and i heard a pop like sound from slave and wife said clutch pedal went soft. shortly after i noticed fluid leaking from slave area.

i've certainly lost the seal. question is, have i done something wrong or was slave bad. at anyrate i'ms certain i need to take it apart again and the spacer is still in the cover plate with splines in. this is good.

any advice welcome here.

thanks, chris.
Reply
Save
Like
1 - 2 of 4 Posts
C
yahoo, finished the clutch job. well actually not complete. i still have install the clutch cover, thay won't be fun, and also the hood.

what a job. got it down to science now though. anyone in the louisaina area feel free to contact me for help.

thanks to all for the heplful advice.
Reply
Save
Like
1 - 2 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
SaabCentral Forums
SaabCentral forum the most comprehensive Saab resource on the internet. Join our discussions on the Saab 9-3, Saab 9-5, Saab 900, Saab 9000 and all other Saab models, choose your forum.
Full Forum Listing
Explore Our Forums
9-3 Sedan, Cabrio '04+, Combi, 9-3X Workshop NG900 & OG9-3 Workshop 9-5 Workshop C900 Workshop NG900 & OG9-3 Performance, Mods & Tuning
Top