SaabCentral Forums banner
1 - 1 of 1 Posts

·
Registered
Joined
·
257 Posts
Discussion Starter · #1 ·
Can't figure this out guys. First my blower for the ACC is not working. I can make it run if I jumper out the resistor pack, but then I just get cold air.
It says on the townsend site to check the voltage at pin 14 of the ACC and it should be 0-5volts. I am not seeing this. I do see 4.5 on the blue wire at the resistor pack though. I have no codes when I run the diagnostic. Again no fan and when I jumper the fan no warm air.
Any Ideas?
 
1 - 1 of 1 Posts
Top