SaabCentral Forums banner

1 - 6 of 6 Posts

·
Registered
Joined
·
511 Posts
Discussion Starter #1
Hello All,
I have a new to me 08 9-3 Aero, working thru problems and incorrect repairs that were made in the past. O-the fun.

I found the front O2 sensor, on the V6, connector to be missing the lock. Currently it is wire tied together. I was hoping to find a replacement connector for the engine harness side so i can make things right. I have been searching for it unable to locate the P/N.

I'm not sure if this is sold separate or if i need to try to find a used one.
I hope someone here can help me out.

Thanks
 

·
Registered
Joined
·
511 Posts
Discussion Starter #4
By they way, the old connector should have a part number written on it
Thanks for the quick reply and the part number, i will check the connector to see if i can find a part number on it. Good idea.

That part number is for a four pin, the one i'm dealing with is a six pin. Looks like the mate for this.
 

Attachments

·
Registered
Joined
·
511 Posts
Discussion Starter #5
By they way, the old connector should have a part number written on it

Again, thanks for the idea. Part number was on the connector, and is on order.
Just in case anyone else is looking for it. Not a Saab part number, but a Bosch.

BOSCH Ignition System Plug Sleeve Connector 1928404900
 
1 - 6 of 6 Posts
Top