SaabCentral Forums banner

1 - 1 of 1 Posts

·
Registered
Joined
·
5,673 Posts
Discussion Starter · #1 ·
Hey I know this might not be the right area, but the performance / mods section isn't super active so if mods feel they need to shift it that's ok.

I want to make up fuel lines for my T5 project, I was thinking of using braided steel line maybe AN4 size or smaller (ID 5.5mm). I have seen others do it and just use small C clamps to hold them onto barbed fittings I know these fittings pre FPR may experience up to 100psi, is this safe?

whats' the best method of securing the fuel lines to the barbs when using rubber core braided steel fuel lines?

Thanks for any help
 
1 - 1 of 1 Posts
Top