[dminieri]

Hi there,

Last night I tried to tighten up my sloppy indicator stalk and in the process, I pulled out the wires that connect to the indicator stalk. I tried putting them back in the correct spots but now the left hand indicator won't work. I'm not sure if I have put them in the correct spots.

Does anyone have a diagram of where wires are supposed to sit?

Dom.

 

[Basre]

The wires are on "fit's only one way" plugs..
Suggest taking a good look, yes it's a bit awkward .. then plug the connectors back in.. they only way they go

 

[Jezzadee]

There are some links in this thread that might help.

http://www.saabcentral.com/forums/showthread.php?t=25635

Welcome to Saab Central

Edit - OK, those links aren't going to help at all because none of them work any more :roll: .

 

[dminieri]

Hi guys, thanks for the response. After about 5 hours I worked it out! Yi ha!

Incase anyone else has the same problem here is what I did.

You will notice that there are three rows of pins.
The first row has 2 pins (A and B) , the second has 2 pins (C and D) and the third has 3 pins (E, F and G) So 7 pins it total. Pin A and E are on 45 degree angles while the rest are verticle.

There are four plugs.
One has blue and white wires (plug 1), the second has a green wire (plug 2)
the third has red and white wires (plug 3) and the fourth has a red wire (plug 4)

Plug 1 goes into A. Plug 2 goes into C. Plug 3 goes into E and plug 4 goes into G.

That's it! It's all working now and I even fixed my sloppy indicator arm, but that's another story!

Dom.