SaabCentral Forums banner

1 - 2 of 2 Posts

·
Registered
Joined
·
1,121 Posts
Discussion Starter #1
I am sure there is simple answer for how to get the largewiring loom that penetrates the false bulkhead out of the way on a 1997 9000, butI cannot see it. Do I simply undo the 5 torx head screws on the large plasticcover from the engine compartment side of the bulkhead?

 

·
Registered
Joined
·
2,791 Posts
I am sure there is simple answer for how to get the largewiring loom that penetrates the false bulkhead out of the way on a 1997 9000, butI cannot see it. Do I simply undo the 5 torx head screws on the large plasticcover from the engine compartment side of the bulkhead?

you can't get it out of way. you have to pull the whole harness out. I changed one out once, I recall it being PITA. That spot where mice climb up on the oil tube and chew out the fabric was bothering me. I replaced the whole fire wall piece opposite the engine. At That ...wiring harness had to obviously be removed to do so. I recall removing it from ECU and pull it out.
 
1 - 2 of 2 Posts
Top