SaabCentral Forums banner
1 - 2 of 2 Posts

· Registered
2008 9-3 2.0T
Joined
·
1 Posts
Discussion Starter · #1 ·
Hey there I have a 2008 9-3 2.0 I recanted replaced the head gasket and know when I start the car a let it warm up it stars to just spew coolant out of the coolant reservoir. I’ve replaced the thermostat, coolant reservoir cap, and I’m about to try to replace the coolant temp sensor and see if that works. If anyone has any other ideas please let me know.
 

· Registered
Joined
·
3,275 Posts
With cold engine, remove cap and, use two latex gloves one to seal bottle cap opening and one to seal the rear small vent, start the engine, does the gloves inflates in the first few minutes ? U might be actually able to see them inflate in small puffs, if thats the case, bad head job/cracked head/block.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top