SaabCentral Forums banner
1 - 2 of 2 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
Hey guys hope all is well. Purchased a 92 convertible 900 turbo a couple weeks ago and ordered a Turbo vanity plate to install in the front.

Unfortunately the plate is a little bit bigger than the recess in the bumper and the supplied spacers don’t space enough so the plate caves in.

i was informed from the seller that a solution would be to use the factory bracket that came with them and cut off the bottom part since I won’t be using a North American plate in the front. Unfortunately I don’t have that bracket so I’m trying to find one.

im a little confused as I stumbled upon two pieces that look to either be two options or need to be installed together. In order to mount a plate. The diagram i found was a little confusing. If anyone had any insight would be. Much appreciated .

part #’s :

6921142
8258428
Land vehicle Vehicle Grille Hood Motor vehicle
 
1 - 2 of 2 Posts
Top