[synoptik]

Is this possible? I'd like to bypass the pedal switches so the APC doesn't revert to base boost when they are pressed.

 

[Kaas]

Yes it can! Look at James from saabworks homepage! His APC mod removes that funktion!
Its just to remove one diode!

 

[synoptik]

Yes it can! Look at James from saabworks homepage! His APC mod removes that funktion!
Its just to remove one diode!

I can't figure out where to go to get information on how to do this.
Where is James's homepage?

 

[Jezzadee]

http://www.saabworks.com/

 

[synoptik]

http://www.saabworks.com/

I've been there. I found the APC modification page but could not find out what to remove or change to bypass the pedal switches, it doesn't say.

What does removing these change?
R=resistor C=capacitor D=diode
Remove R104

Remove C28

Remove R40, and replace it with 1k ohm Resistor

Remove C25

Remove C26

Remove D36

Remove the wire patch between R103 and R51
(physically between, not electrical connection)
Remove C31

 

[Kaas]

As I remember it! It is D36 you shall remove! I remember that its placed about a border somewhere! I think its about the contakt housing!