SaabCentral Forums banner
1 - 2 of 2 Posts

·
Registered
Joined
·
431 Posts
Discussion Starter · #1 ·
i have an alloy wheel which is 5 x 110 bolt config, but the centre hole in the wheel is about 62mm diameter , its just a couple of mm too small to go on the 9-5.

Is there a solution ? is it just a case of getting one of those conical drills and widening the hole ? or putting into an engine shop or precision engineers ?

Anyone had experience with this type of problem
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top