Airflow sensor
1 - 4 of 4 Posts
Joined
·
2,015 Posts
If you mean the MAP sensor, both vehicles use the same part - just remove it from the 94 and put it in the 91.
Two mounting screws, the electrical connector and a rubber hose.
1 - 4 of 4 Posts
Join the discussion
Recommended Reading
-
Idle Issues - what's left to diagnose?
9000 WorkshopI recently purchased a 1988 9k with 176,000+ miles on it. Overall the car drives great and has a very small list of to dos given what I paid for it. The most troublesome issue I am facing right now is a idle/cold start issue that does not seem to cure with the normal remedy's. So far I have...- 2
- 144
-
1994 9000 NT CDE Project
9000 WorkshopJust acquired a 1994 9000 non-turbo 5-speed and will be refreshing it after sitting for over 4 years. It sat near salt marsh for several years so it has surface corrosion on various places and it needs some major cleaning and cosmetic touches. The clutch needs work, no fluid pressure. Got it to...- 45
- 997
-
Ryengoth · updated
-
Auxiliary Lights for your 9000 , Lets See 'Em
9000 WorkshopWhat is everyone running for auxiliary lighting on their 9000? Please post a photo. What type of lights and how did you mount them?- 3
- 86
-
godwinaustin · updated
-
'98 9000 CSE m/t - persistent p0444
9000 WorkshopHello folks, Have been struggling with p0444 on my 9k. I juggled 3 different evap valves (2 of which I know to be good, but technically wrong p/n, the bosch 300 and 308, but I had success with 308 before). I followed the testing procedure for the manual. Valves measure ~26ohm, resistance from...- 6
- 254
-
lorylke · updated
-
Nut pitch and size for shift rod bushing
9000 WorkshopDoes anyone happen to know the thread size and pitch for the nut that screws onto the bushing studs for the manual trans? I looks like it might be M6x1.0 but if someone knows what it is I can avoid buying the wrong size. The engineers of this 9000 model apparently try to utilize every possible...- 1
- 54
-
Ryengoth · updated
Join now to ask and comment!