SaabCentral Forums banner
1 - 6 of 6 Posts

·
Registered
Joined
·
11,383 Posts
You should replace spark plugs and coils ASAP. They look horrible.
Have you erased all DTCs before read?
 

·
Registered
Joined
·
11,383 Posts
They look that they were in place since 2010. I'd say that these caused your issues.
No oil etc. supposed to be there.

Remember that only original coil and NGK spark plug will work.

Are those DTCs after erase and re-read?
 

·
Registered
Joined
·
11,383 Posts
ACC SEAT TEMPERATURE SENSOR B1927

ACC COMPARTMENT TEMPERATURE B0166

ACM DRIVER SEAT POSITION B0084

BCM OUTDOOR TEMPERATURE B0158

BCM UAM, SIGNAL ERRATIC B3812

BCM UAM, SIGNAL, OPEN CIRCUIT B3812

DDM MIRROR UP/DOWN POTENTIOMETER B1595

T8 CYLINDER 2 MISFIRE PO302

T8 FUEL LEVEL SENSOR CIRCUIT P0463

T8 ENGINE COOLANT SYTEM P0116

T8 CHARGE AIR BYPASS P0033

REC TRUNK LIGHT CIRCUIT B2570

REC BACK UP LIGHT LEFT B2545

STC 1ST BOW LOCKED B1300

REC FRONT WASHER RELAY B3873

REC SIDE MARKER LEFT FRONT B3871

REC SIDE MARKER RIGHT B3872

REC LOW BEAM LEFT B2575

REC LOW BEAM RIGHT B2699

REC HIGH BEAM LEFT B2580

REC HIGH BEAM RIGHT B2580
ACC B1927 seat heater censor failure, typically wire broken. Check wiring loom between ACC and seat(s), if they are OK, replace heater element.
ACC B0166 cabin temp sensor failure: Check wiring loom between ACC and sensor, if OK, replace sensor.
ACM B0084 seat position sensor failure, check wiring under seat.
BCM B0158 ambient sensor failure. Check wiring and if OK, replace sensor.
BCM B3812 cabin ultrasonic sensor failure, check wiring looms between BCM-REC-cabin light assy. If ok, replace sensor.
DDM B1595 driver door mirror motor failure. Check wiring between DDM and mirror, if ok, replace mirror motor.
T8 several failures, possible T8 failure, replace T8.
REC several failures. Replace bulbs.
STC B1300 1st bow lock failure. Check wiring, if OK, replace lock module.
 
1 - 6 of 6 Posts
Top