Search Results for ‘vacuum’

HI folks, Does anyone happen to know what the inside diameter is for the vacuum lines for a 2008 9-5 Aero? I'm looking to replace the stock ones with silicon and was going to buy a length of silicone line from eBay. Thanks much. [email protected]

ok so i have full 2.5 exhaust, cai, SD APC, and stock FPR....why am i only getting 8 psi?????....i have all silicone vacuum lines and i KNOW there are no vacuum leaks....WHATS GOING ON!!! thanks everyone

Car: 2002 Saab 9-5 Linear Issue: Car first threw a code for needing a new MAF, only one code was thrown and was for that.(Forgot the exact code). Replaced MAF, even had a Eurospecific shop confirm it was that which needed replacing. Once installed,(easily replaced), the car now throws p0108 for...

Last few days I've been driving the 81 turbo sedan to/from work while landcruiser is undergoing some major steering work, and I noticed that the power is seriously lacking plus it was sounding like there was a continual vacuum 'leak'. Well I had a look once I got home from work and sure enough...

Another interesting turn of events for my goose. Good News: After some fiddling and a bit of WD-40, the microswitch for my top decided it wanted to play nice again, and started to work in the middle of a 30 mile commute this week. No more irritating SID chimes, for now. Removed the rear...

I found the vacuum hose in the picture disconnected. It had a small plastic nipple it was attached to that looks like it broke off whatever part it belongs to. Could someone tell me what part of the engine this particular hose should attach to? Thanks, Rowland

I just replaced a bad GT17 Turbo with a T25. Now the car starts almost immediately, but will not stay running. The gas pedal does nothing but make it stall faster. I tried holding the gas pedal down while cranking and it would not start. But, if i release the pedal it will start right up and run...

Hello all, Recently Purchased a 99 9-3 2.0, with 168k on it. all seemed to be well until i got on it. The car builds boost fine and accelerates until i hit about 3200rpm then the car stops accelerating all together and i lose all boost. When i first cracked open the hood i found no cacuum...

Hi, can someone tell me how to fix the vacuum system that works the ventilation? Mine used to make all the right poping, sucky sounds when you turned the vent dial. But recently it stopped doing that and it seems to only blow on full with air only coming out the dash and limited amount to the...

Hello! I'm the owner of a new 2009 Saab 9-3 Aero XWD (2.8L) and I am having my first 'major' issue that I'd like to report and get some advice on. The problem has been there since I first had the car (Jan/Feb 2010) but it's taken repetitive instances of the issue to convince me I have a real...

My car: 1999 9-3 turbo 2.0. i installed a boost gauge and i want to know what the vacuum/boost levels SHOULD be. i attached a picture of where i attached the vacuum line for the boost gauge, is this right?

All parts are from a 1999 93 2.0T Speakers ($120.00 +S&H): (2) Infinity 6022i (2) Infinity 3022cf Red DIC w/ 20K+- ($100.00 +S&H) Hoses: Coolant, vacuum, etc. ($50.00 +S&H) OBO for all this.. Take the lot for $200.00 +S&H [email protected]

I need to replace the top large vacuum hoses that runs from t he throttle body to (I think) the injector rail. While I'm at it I thought I would replace both large hoses and the smaller one that comes off the pcv. Do I need special hoses for this or will regular vacuum hoses work?

Hey I'm installing a boost gauge on my left a-pillar and need to know the easiest place to snake the vacuum tube and wires through the firewall. If you have pics or detailed descriptions of easy locations to do so please do share :) (I think I know where the rubber grommet is but how should I...

Hey I'm installing a boost gauge on my left a-pillar and need to know the easiest place to snake the vacuum tube and wires through the firewall. If you have pics or detailed descriptions of easy locations to do so please do share :) I tried searching and found a couple, but couldn't find the...

Td04 swap in my 95 gm900 complete after the t25 self destructed new turbo is giving around 10pnds but at idle the vacuum reads 15 of mercury says late on timing...I also have hardly any power although the turbo is boosting any thoughts?.