SaabCentral Forums banner

temp

  1. 9-5 Workshop
    Hi Guys, I've got a 2005 9-5 Arc that's been giving me some weird issues. I've been having the coolant gauge turn itself from operating temp to 0 for about 4 years now. No real pattern to it, hot outside the car, cold outside, doesn't seem to effect it other than it gets up to operating temp...
  2. NG900 & OG9-3 Workshop
    Hey everybody. Last week when I was driving on the hwy, I saw the CEL go on, and watched the temperature gauge quickly fall to the bottom. I pulled over and checked the code. It was a P0116 which is something like "temperature sensor circuit failure". So, I ordered a new thermostat and a new...
  3. 9-3 Sedan, Cabrio '04+, Combi, 9-3X Workshop
    Hi, A friend turned up today after virtually ripping the front bumper off his 2009 9-3 convertible. I managed to reattach the bumper but have a problem with the outside temperature wiring. The cable was ripped off somewhere behind the wheel well - behind where the optional fog lamps would...
  4. 9-3 Sedan, Cabrio '04+, Combi, 9-3X Workshop
    Ever since I have had my 2004 9-3 conv, about 8 months, the temp guage has always stayed just below the center 9 o'clock position. I've been through the seasons with low and quite high Phoenix AZ temps. This is when it is fully warmed up when cold it goes down normally. But in the picture that...
  5. NG900 & OG9-3 Workshop
    I've recently started having some issues with my temperature gauge. I've read plenty of instances where folks have replaced the thermostat and/or coolant temperature sensor and plan on replacing both soon since it is a relatively low-cost repair. I am curious about the problem though as from...
  6. 9-3 Sedan, Cabrio '04+, Combi, 9-3X Workshop
    Hi, Last week a tractor-trailer blew a tire in front of me and my only option was to run it over because there wasn't enough time to stop and I couldn't swerve in to the other lane. When this happened it pretty much destroyed the plastic under the front bumper and my outside temp now only...
  7. NG900 & OG9-3 Workshop
    Ok, so I have quite an explanation ahead, but If you have any experience with this sensor or with sensor wiring in general, I would greatly appreciate your input -- thanks in advance! A few weeks back, I got a CEL and autozone read it as a "high intake air temperature" code. Well, my haynes...
Top