SaabCentral Forums banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-10 of 10 Results
  1. 9-5 Workshop
    The car; 2001 Saab 9-5 2.0 turbo B205E 225hp map Open exhaust Big red pod airfilter Vectra coilovers I am having the following problem since I got the car. When driving normally, the engine revs up 200-800 between shifting gears. (Foot off the gas before pressing the clutch) I don't think this...
  2. NG900 & OG9-3 Workshop
    Drove my 98 vert to work this morning. Had a strange hick-up, the car bucked a couple of times driving down the road. All the lights on the dash came on for a few seconds then went out. Drove a couple of more miles to work without indecent. Turning a corner, I noticing that the turn signals...
  3. 9-5 Workshop
    2006 Saab 9-3. I'm having issues with the clutch pedal. Pedal is about an inch from the floor and will not depress far enough to put the car in gear. However, I can push (force) the car into first gear and then drive it while shifting gears without the use of the clutch. The clutch does not slip...
  4. C900 Workshop
    I am the second owner of a '94 CE, it is a 5-speed turbo. It currently starts and drives fine, but after 5-10 minutes of driving, 1st and 2nd gears become impossible to shift into. I have very little confidence that a local transmission shop would diagnose my issue properly, and that the costs...
  5. 9-5 Workshop
    Hi there-- I am by no means a car expert, so bear with my terminology. I've owned my Saab 9-5 V6 year 2000 for about 6 years now. I have fixed quite a few problems in the last year. I have cleaned and replaced the neutral safety switch, replaced the crankshaft position sensor two years ago, just...
  6. C900 Workshop
    97 saab 900s shifts but doesnt go into gear, HELP! I purchased a 97 Saab 900s Manual 5 speed and after taking it up and back down powder mountain (a very long and steep grade) I've run into a major problem. She shifts but she doesn't go into gear. I made it about 3 blocks from my house and...
  7. NG900 & OG9-3 Workshop
    Hey Yall, Newbie here, so forgive my innocence. I have a 2002 9-3 convertible with a 5 speed manual transmission. Recently I've been having trouble getting it into reverse and it grinds a little going into 5th. I usually have to be rolling backwards to get it into reverse, even if its just a...
  8. 9-3 Sedan, Cabrio '04+, Combi, 9-3X Workshop
    Hey Yall, Newbie here, so forgive my innocence. I have a 2002 9-3 convertible with a 5 speed manual transmission. Recently I've been having trouble getting it into reverse and it grinds a little going into 5th. I usually have to be rolling backwards to get it into reverse, even if its just a...
  9. NG900 & OG9-3 Workshop
    Hi, yesterday my 95' 900 se turbo failed to shift into first and fifth gear, second is a little tough aswell. so i researched the problem and decided my shifter linkage has gone because it has a very lot of play almost like something has broken off of it. instead of buying a new linkage assembly...
1-10 of 10 Results
Top