SaabCentral Forums banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-3 of 3 Results
  1. 9-3 Sedan, Cabrio '04+, Combi, 9-3X Workshop
    My window seal (run channel) seems to have torn. This is now causing the window to pinch it on the way up and it either takes 5 trips up and down to get the window up or just pure luck. I can see that it is torn, so my question is how hard is it to change this seal or run channel. I have...
  2. NG900 & OG9-3 Workshop
    My wonderful synthetic oil is leaking out of my main seal faster than I can dump it in. It seems like a pretty straight forward process to take off the crank pulley and install a fresh seal: 27mm socket with breaker bar/neanderpole for leverage, remove pulley, pull out retainer clip, swap bad...
  3. 9-5 Workshop
    Rebuilt engine and put new seals in transmission and reassembled. Car ran great for 1800 miles. During hard acceleration engine over rev'd and trouble light came on, car continued to run fine. About 10 min. later smelled oil and pulled over, at same time transmission started to slip and car...
1-3 of 3 Results
Top