SaabCentral Forums banner
saab 93 2.0t
1-10 of 10 Results
  1. NG900 & OG9-3 Workshop
    Hello everyone. I am New here and I hope my question is in the right place. My turn signal clicker not working. Do you know where is the clicker located ? And the other problem is that the system sounds not working too - when is open door, soft top moving, seat belt.. Can you help me, what I...
  2. 9-3 Sedan, Cabrio '04+, Combi, 9-3X Workshop
    Need a few pointers. My 09 93 2.0t xwd.165km My xwd does not work. Hasn't for about a year. But im wanting to solve the issue. There are absolutely no codes. Had a good saab buddy mess around with tech2 and he couldn't figure it out either. There's no service lights either. I can turn traction...
  3. 9-3 Sedan, Cabrio '04+, Combi, 9-3X Workshop
    I am currently trying to help my friend troubleshoot his 04 9-3 linear. Back in 2016 his car was dying in traffic at random times, and after doing some research we assumed it was the crank positioning sensor. He purchased the part, but due to him moving and logistical issues we were only just...
  4. 9-3 Sedan, Cabrio '04+, Combi, 9-3X Workshop
    Have recently bought a 2005 saab 93 vector 2.0T, amazing car but the high beam problem i currently have is driving me nuts! High beams come on for "flash pass" on the first click only, I can feel the second toggle as the stalk is pulled further but the high beams then go out with the light on...
  5. 9-3 Sedan, Cabrio '04+, Combi, 9-3X Workshop
    So I have a 2008 93 2.0T with a stage 3 tune from MPS. I recently decided to get a replica Hirsch Diffuser installed and it looks great. Afterwords I got the dual exhaust to match (already had a OBX down pipe). Problem is, ever since I had the dual exhaust put on, it has been rattling a lot...
  6. 9-3 Sedan, Cabrio '04+, Combi, 9-3X Workshop
    I have a 08' 93 2.0T and I have been wanting to do a diffuser for quite sometime, but I was wondering if anyone else has done this and the experience they have had with it? Was it hard to install, paint, if you hired someone was it expensive for the labor, etc. This is the one I am looking to...
  7. 9-3 Sedan, Cabrio '04+, Combi, 9-3X Workshop
    I brought my Saab 93 in because I had to have 2 FOBs programmed and the module behind the steering wheel replaced. When I left the shop turning the wheel made noise. The noise got worse and I brought the car back in. The shop says the bearings are bad in the steering column. They would have...
  8. NG900 & OG9-3 Workshop
    How would I tell if I had a Garret GT17 or a T17 turbo? The specs are a little confusing. I have a 2000 Saab 93 2.0T
  9. 9-3 Sedan, Cabrio '04+, Combi, 9-3X Workshop
    We recently purchased a 2005 Saab 93 Linear for my stepdaughter. We've had a bit of a time with it so far. Replaced the front strut assemblies and had to weld a hole in the oil pan. Just when we thought we were in the clear......more problems. Here's the story. We were headed out the...
  10. 9-3 Sedan, Cabrio '04+, Combi, 9-3X Workshop
    I am getting my OBX downpipe installed tomorrow. I am getting my tune next week. Is the car safe to drive with out tune and just downpipe?
1-10 of 10 Results
Top