SaabCentral Forums banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-2 of 2 Results
  1. 9-3 Sedan, Cabrio '04+, Combi, 9-3X Workshop
    Good evening guys, I just got my stage one Maptun tune and installed it, did two key cycles and got a check engine light for rod knock detection sensor I cleared it and drove because it sounded the exact same, drove it around a bit seemed a little more torquey getting off the line but...
  2. 9000 Workshop
    This is a 1997 SAAB Aero just rolled over to 130,000 miles. Noise came on in about 3 miles of driving. I can't figure out if this noise is from rod bearings or a stuck tappet. http://www.youtube.com/watch?v=RaqCkFAMxSY#t=1m38s The whole two-minute video is here...
1-2 of 2 Results
Top