SaabCentral Forums banner

power seat

  1. Swapping Driver Seat to a memory seat

    9-3 Sedan, Cabrio '04+, Combi, 9-3X Workshop
    Hi everyone! I am new on the forum although I have ready threads from it many times in the past :D I am currently trying to see if I can improve the look and feel of my 2006 9-3 Seda 2.0T driver seat! It works perfectly, but the cushion has more wear than I would like and the trim that holds...
  2. Electric driver's will not function

    NG900 & OG9-3 Workshop
    What are common reasons that my drivers seat will not move at all. I don't hear any relay noises. Is there some electric Saab feature that might prevent movement?
  3. How to operate power seat outside car?

    9-5 Workshop
    Hi there. I am currently building a racing cockpit at home and bought a passenger power seat from a 2001(?) 9-5. We're trying to figure out how to get the controls to work to adjust the seat via 12V/12A coming from a battery charger with a lighter plug on its back. Will that work? We found...
  4. Power seat issues....

    9-5 Workshop
    I had my memory buttons for my seats sticking so I took off the trim and pushed out the memory buttons and cleaned them with water...reinstalled and then the next day the buttons were stuck again. I did this process again and used alcohol...thought it would be better because it would evaporate...
  5. Removing Power Seat Buttons

    9-3 Sedan, Cabrio '04+, Combi, 9-3X Workshop
    I'm replacing the plastic trim on the driver's seat and I need to take the buttons off that move the seat. Does anyone know how to take the buttons off of the module so that I can remove the plastic trim? Thx.
  6. Power Seat 2002 9-3 SE Intermittent

    NG900 & OG9-3 Workshop
    Just picked up another Saab but can't figure out an issue. Passenger power seat works with no problem but the drivers seat it intermittent. When pushing a switch and holding it the seat will move for 1 second, stop for a second and continue this cycle until it gets where it needs to go. I'm...
  7. Power Memory Seats

    NG900 & OG9-3 Workshop
    I'm attempting to install power leather seats in my 1995 900s , there is no existing wiring for the power. I can run 12v to make the seats move, however I'm not sure how to make the driver's side memory work. Any diagrams or info would be greatly appreciated Thanks
Top