SaabCentral Forums banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-8 of 8 Results
  1. 9-5 Workshop
    I'd like to connect a OBD display, but even with the smallest plug I had found it won't work since I can't close the flap covering the outlet. Any suggestions here? (BTW, does anyone know if the OBD protocol Saab is using does also give out the oil temperature?)
  2. 9-3 Sedan, Cabrio '04+, Combi, 9-3X Workshop
    Anyone got a link for one that will fit for me? It’s the valve plug on bottom side of radiator for draining coolant. 2008 9-3
  3. 9-3 Sedan, Cabrio '04+, Combi, 9-3X Workshop
    I ended up stripping the 12mm hex on the transmission fluid drain bolt and the torx screw that goes inside of it snapped in half so I have been looking around for a replacement. I believe the 2007 aero 6-speeds come with the AWTF-80 SC transmission? And the only bolt I could find online is sold...
  4. C900 Workshop
    So the wires leading to the throttle position sensor have corroded to the point that I can't even solder the wires reliably. The three prong plug connecting to the throttle position sensor works fine but the wires need to be replaced or fixed some how. The attached picture shows where the...
  5. NG900 & OG9-3 Workshop
    I was planning on changing my transmission fluid on my 02 93 but when I was looking through my Haynes manual it said to replace the washers on the drain plug, check plug, and fill plug. However, I couldn't find this washer anywhere online to buy and the schematic at thesaabsite didn't even have...
  6. NG900 & OG9-3 Workshop
    I have 2000 Saab 9-3 that is blowing smoke. I know, I know. Typical signs of the turbo going out. However, the reason I am writing in here is to ask a question about it...I just recently purchased it, I do not have service history of the vehicle, and I do not know what kind of oil has been used...
  7. NG900 & OG9-3 Workshop
    Hello, I have been following all the different threads in this site with a lot of interest!! ;ol; I have learned a lot from all of you, now I need a little bit of help. I have been dealing with a leaking valve cover gasket, which I have removed the valve cover and I have cleaned up. I also...
  8. NG900 & OG9-3 Workshop
    Hey guys, This is my first post on this forum after recently acquiring my first Saab, an '02 Viggen we've named: Tiff, since she's sure to be a spoiled little... let's say girl. After doing some poking around near the MAF to see why my check engine light was on, I made an odd discovery. It's...
1-8 of 8 Results