SaabCentral Forums banner

p1260

  1. P1260 and P0100 codes

    9-5 Workshop
    Hello! I recently purchased a 2003 9-5 Linear with 180k miles. The dealership replaced the fuel pump right before I bought it because they said it died when they started it. The check engine light came on shortly after I bought it (same day actually). Then I noticed when I was idle at a red...
  2. Not getting good Turbo Boost, it never goes to Red, little sluggish when cold started

    9-5 Workshop
    I just bought 2001 Saab 95 Turbo 2.3L After getting couple of problems, (Invalid Idling speed, Not enough pickup and couple of error codes) I replaced, ByPass Valve, O-Ring on top of Throttle body and Turbo Boost Control Solenoid Valve, Now I get little bit better pickup then before but still...
  3. Idling RPM remains at 2000 after flooring Gas Padel

    9-5 Workshop
    I have 2001 Saab 95 2.3 Turbo 4 Cylinder, as soon as I Push the GAS paddle to floor, it would turn check engine light on, Turbo Gauge remains in yellow never got into Red zone, then on leaving the Gas to Idling, RPM remains around 2000 , until I clear the codes using OBD 2, tested this couple of...
  4. Ideling RPM remains at 2000 after pushing Gas padel to full

    9-5 Performance, Mods & Tuning
    I have 2001 Saab 95 2.3 Turbo 4 Cylinder, as soon as I Push the GAS paddle to floor, it would turn check engine light on, Turbo Gauge remains in yellow never got into Red zone, then on leaving the Gas to Idling, RPM remains around 2000 , until I clear the codes using OBD 2, tested this couple of...
  5. P1260 error & missing parts on my engine?

    9-5 Workshop
    Hello everyone, I am a new owner of a used 2001 Saab 9-5 with the 4-cyl 2.3L engine. I've owned it for about three weeks and it's been running beautiful, but just got stuck in "Limp Mode". Error codes I got were... P1260; throttle return spring too low force P0116; enginee coolant temperature...
  6. Do I need a new throttle body?

    9-5 Workshop
    I was popping p1251 and p1260 codes. Installed new fuel filter and every now and then getting p1260 again. Next I removed the throttle body to reset it out of limp home mode, in doing that I popped that darn check valve in to, replaced the check valve and cleaned the throttle body with seafoam...
  7. P1260 & TCS off relationship?

    NG900 & OG9-3 Workshop
    Yesterday my wife's 2002 9-3 SE 2.0 Auto had the "Check Engine" light illuminate in addition to the "TCS off" light as well. I pulled the code and it read P1260. I believe that code indicates a weak throttle return spring which I think is adjustable. I am wondering why the TCS off light would...
Top