SaabCentral Forums banner

obdii

  1. 9-3 Sedan, Cabrio '04+, Combi, 9-3X Workshop
    Ok SAABer's, here is the situation, i just completed the fuel sensor level swap (including Dropping the tank) in my '03 9-3SS 2.0t friday and saturday 6/15 & 6/16 and completed everything in 18 hours. Now im getting a CEL and when i read my OBDII with my reader it comes up with P1805 and P0420...
  2. NG900 & OG9-3 Workshop
    OBDII on a RH drive 1997 NG900S? Hi there, I've got a 1997 NG900S v6 2.5lt with the OBDII jack under the instrument panel and it's a right-hand drive (as I am in Australia). I've attempted to connect a OBDII reader but it's not being recognised at all. I contacted the seller of the OBDII...
  3. C900 Workshop
    Hi, folks I was told that an OBD2 code reader could be useful for diagnosing problems (of which I have none at present), and found a cheap one at my local car parts store. I didn't buy it, though, because there was no way to see from the manual what kinds of cars it would work with. I also...
  4. NG900 & OG9-3 Workshop
    Recently purchased a 1996 900SE Turbo automatic. Had new radio installed and noticed when I got the car back that a black wire to the OBDII was pulled out. Cannot get the car smogged until I figure out which hole the pin goes into. Does anyone happen to have a wiring diagram for the OBDII...
Top