SaabCentral Forums banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-12 of 12 Results
  1. 9-3 Sedan, Cabrio '04+, Combi, 9-3X Workshop
    Apologies for rust as I live in Minnesota. Does anyone know where to find this mount? And is it a common leak issue?
  2. 9-3 Sedan, Cabrio '04+, Combi, 9-3X Workshop
    Hello I’m looking to replace my transmission mount that mounts to the front of the car. I’m looking to sell my saab and want to make sure all the bushing and such are fixed. But I’m having a hard time finding the exact mount or bushing I need. Here’s a picture. I’m looking for mount “19A”. I’ve...
  3. 9-3 Sedan, Cabrio '04+, Combi, 9-3X Workshop
    2003 9-3 2.0t code p0780 mechanical fault while downshifting Rough shift 1shift 2shift slip an engage at 3rd shift under load i dnt go over 40mph hard stop under 15mph then a kick from the trans at 0 with breaks and without Also was told it need a motor mount 133xxxmiles only 1rust small rust...
  4. 99 & 90 Workshop
    Hi Friends. I believe I need a new front motor mount for my 1976 SAAB 99 GL manual (I am assuming the rubber cushion has worn out), but the rubber "cushion" is apparently no longer available: P/N 8379281 / 837928. I have scoured the entire earth, and have found 0. Does anyone know of a generic...
  5. NG900 & OG9-3 Performance, Mods & Tuning
    Ok so I just got the infamous 96 shift link problem fixed by getting a new shifter put in, $500 later... I still have problems with it popping out of gear if I rev the RPMs to high in any gear the shifter wants to pop out of place or if I go in reverse too fast it still wants to pop out of gear...
  6. NG900 & OG9-3 Workshop
    I had a large rock that cracked my transmission in several spots and found a few replacement transmissions but i wasnt sure what years id be able to swap with transmissions. Im mainly wondering is i could use a manual 1999 93 in my manual 1996 900. Also if you may know if im able to get the rear...
  7. NG900 & OG9-3 Workshop
    Does anyone know about leaving the motor mount loose? I was told that it helps with cornering?
  8. NG900 & OG9-3 Workshop
    99 9-3 convertible. The left front had a shimmy when accelerating a couple of years ago. It turned out being a broken front left motor mount. Now I have an issue on the right side which is worst when turning to the left and accelerating. It also happens slightly at freeway speeds with power...
  9. 9-5 Workshop
    99 9-5 2.3t automatic. Vibration on interstate 60+, super annoying, motor mount under large bracket was replaced(if looking at the engine its on the left). Strange clicking noise when shifting gears from 2 to 3 (cars automatic), vibration at stop while in drive, but not when in park. Suspect its...
  10. C900 Workshop
    I finally got around to purchasing a mounting bracket for my 92 saab 900 N/A . I've never changed an engine mount, and I'm wondering what the procedure is. Do I need to get an engine hoist and lift the front of the engine? Do I use a jack? If anybody has done this procedure before I would...
  11. C900 Workshop
    It looks like the part which connects to my motor mount is broken, and I'm missing one of the bolts, however I think the mount itself may be good. Can anybody help me identify the part? Maybe I can find one for sale on the net'.
  12. NG900 & OG9-3 Workshop
    Ok so i think im missing my top motormount on my 1999 saab 9-3. The bottom one under the car is there, but the top one on the passenger side is missing... no bracket or anything. Does anyone have a picture of one or know where i can get one? i dont even know what it's supposed to look like. any...
1-12 of 12 Results
Top