SaabCentral Forums banner

manifold

  1. 9000 Workshop
    Hey everybody! New to the SaabCentral forums, and I have a probably stupid question, but I can't find anything around that explains to me what I'm seeing. I was cleaning the engine bay on my 1994 9000 Aero recently, and I noticed a small diameter hose leading into the intake manifold that isn't...
  2. 9-3 Sedan, Cabrio '04+, Combi, 9-3X Workshop
    Getting ready to address a CEL related to the SAI Valve (Code P0411). In tackling this, I realize that the intake manifold is coming off, and am wondering what else I should replace/check/clean, etc. as this is looking like a solid day at minimum to perform the replacement. Currently have 51k...
  3. C900 Workshop
    So I finally got the clutch and clutch line put together, and in the process I knocked off a black, ~16 gauge wire that appears to ground at the intake manifold (just behind the throttle). At the time the wire appeared to go to the alternator negative, so I bolted it on there. But afterwards...
  4. 9-3 Sedan, Cabrio '04+, Combi, 9-3X Workshop
    Soo, after seeing bratboy successfully install our b207r into the supercharged balt ss and my excess of free time due to a broken back and not much else to do I've been looking at mods that may work on our car. I think some of these with the addition of an ECU flash may be a nice way to broaden...
  5. C900 Workshop
    I found the vacuum hose in the picture disconnected. It had a small plastic nipple it was attached to that looks like it broke off whatever part it belongs to. Could someone tell me what part of the engine this particular hose should attach to? Thanks, Rowland
  6. 9-3 Sedan, Cabrio '04+, Combi, 9-3X Workshop
    I have a 2001 93 that just failed emissions ;oops: and I have the codes that caused the failure. About 2 yrs ago I replace the original engine with an Ecopower 2.0 Turbo. I've been looking up the codes online as I want to attempt to fix these gremlins myself, the codes are as follows: P0455...
  7. 9-3 Sedan, Cabrio '04+, Combi, 9-3X Workshop
    Hey does anyone know what Opel has done to the new 2010 Opel Insignia engine? It's the same "LP9" engine as our beloved 2.8L V6 Turbos, (I have an '08 Turbo X) but they're getting 325bhp stock out of it. Whereas my Turbo X was only 280bhp stock. My previous owner did a Stage 1 upgrade to...
  8. NG900 & OG9-3 Workshop
    So i've been on here asking about my saab before, to see if anyone could give me hints, I had a couple of issues that I thought were related, turns out, they were both seperate problems. One of which I fixed, which was a small short under the center console by the ignition lock cylinder. My...
Top