Search Results for ‘heater blend door’

Hi all, working on an 02 9-5, no heat/cool temperature changes on the drivers side. ACC codes initially were 06 and 13, the 13 has now gone away, just 06 now. The TL;DR is - Does code 06 always indicate a bad stepper/blend motor? I held it while running several calibration tests and felt...

Hello, so as the title says, I have a couple of issues with my 9-5 AC. Whenever I drive at speeds faster than 60 km/h I seem to get air coming out of my vents, and it's usually hot air. I was told that there's a flap that opens/closes coolant access to the heater core, and mine is stuck in...

Hello all, I hope everything is good in whatever part of the world you are in. The Saab I drive is a 2001 9-3 SE HOT. The car starts and warms normally, shows the proper temperature on the gauge, there is a new (less than 2 months old) thermostat in it, and the blower motor runs normally at...

Hello, have an issue with MY01. had issues with climate control sometimes not blowing hot air and getting stuck , not allowing to change air distribution ACC calibration displayed fault codes 08 and 11. The car was fixed in an authorised Saab workshop , they told me they have replaced one of...

Hi guys, so lately I've had codes 8 and 13 pop up on my AC unit, with only cold air coming out from the driver side vents. so I went to the stealer and told them what the problem was and they told me they had to take out the entire heater box out to see what the problem was. and they also found...