SaabCentral Forums banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-18 of 18 Results
  1. 9-3 Sedan, Cabrio '04+, Combi, 9-3X Workshop
    A squirrel ate clean through some wires in my SAAB (video attached). Anyone know what they are and where the long end of it goes? I can see the clip on the short side but not the long end (haven't been able to remove ECU and look super hard yet due to rain) and wasn't sure how easy it will be to...
  2. Audio, Video, Navigation & Security
    Hey everybody, So I found a working ICM3 unit in a newly dumped 93 at my local pick'n'pull. The console works perfectly and was in great condition. The DVD-ROM drive however not so much I think. When I went into the trunk to remove the unit I found the harness coming out of the drive looking...
  3. 9-3 Sedan, Cabrio '04+, Combi, 9-3X Workshop
    Found an interesting site that seems to have a plethora of wiring diagrams for many makes and models that is searchable: https://www.revbase.com/BBBMotor/Wd I did check and it has wiring diagrams for my 2004 9-3. Just passing it along.
  4. NG900 & OG9-3 Workshop
    My starter decided to go kaput over the weekend after I changed the headlight bulbs out. But when I took out the starter, I noticed a wire that doesn't look in good condition. I have no clue what this wire connects to or what it does, and It doesn't seem possible to find a good wiring diagram. I...
  5. 9-3 Sedan, Cabrio '04+, Combi, 9-3X Workshop
    Hey folks, I've probably tried to run this question by before but I can't find it. I've got a 04 9-3 Aero and Installed and programmed an ACC unit with heated seats and swapped both front seats from an 06 that had heated seats from the factory. After quite a bit of research, I've learned...
  6. 9-3 Sedan, Cabrio '04+, Combi, 9-3X Workshop
    First post ever so I apologize if this info is on here already - I did quite a bit of searching already and can't find it. I'm trying to replace a rear tail light assembly (broken lens) on my 2006 9-3 Aero Cabrio and can't figure out how to remove the wiring harness. There is no obvious tab...
  7. 9-3 Sedan, Cabrio '04+, Combi, 9-3X Workshop
    I've replaced my upstream o2 sensor multiple times and CEL keeps coming on. As it turns out, it's the harness where the sensor connects to the wiring that leads to the computer that is the problem and not the o2 sensor. I can move the harness a little to make a bit of tighter connection, and...
  8. 9-3 Sedan, Cabrio '04+, Combi, 9-3X Workshop
    I had a fire in front of my 04 9-3 fuse relay box under the hood. All of the wire harnesses were melted at that point. Ive replaced the engine harness. Now there are two more harnesses that need to be replaced. One is for the headlights and the other goes into the cab. What is the one that...
  9. Parts for Sale/Wanted - North America
    Name: Jared Location - additional details: PA Means of contact: PM Price: Description: My 2007 2.0T doesn't have fog lights. To install I need the lights, harness and switch. If anyone has one or all from a part out, spare or whatever let me know with price you want. Thanks!
  10. NG900 & OG9-3 Workshop
    My buddys 2001 9-3 blew its fuel pump at 144,000 miles which it is currently still at. He drops off the car, I put in a very clean and tested but used fuel pump and he only got halfway to work the next day. Long story short, He again blew the second USED fuel pump that i put in. I know they were...
  11. 9-3 Sedan, Cabrio '04+, Combi, 9-3X Workshop
    New owner here, and I had some dried battery acid to remove from the driver's side of my 9³'s engine compartment. Apparently, one of the connectors came loose when I removed the battery tray for cleanup. NOW THE CAR WON'T START. Dash lights up like Christmas but when the key is turned--...
  12. Parts for Sale/Wanted - North America
    Me and my friends used to be into flashing our Saabs and just have a lot of left over hardware from over the years. I came across a box i completely forgot about until now. I am hoping some people on this forum can put it to good use. Willing to Sell everything as a whole lot, will combine...
  13. C900 Workshop
    Ever since I got my Saab I've lived with not having a stereo for the simple fact that I cannot, for the life of me, find the main hookup to connect to the deck. I've searched in the deck slot, I've looked through the dash speaker holes, and now I've taken out the knee bolster as well. Still no...
  14. Parts for Sale/Wanted - North America
    We are looking for an ECM unit and an uncut matching engine electrical harness for a 1992-1997 Saab 900 Turbo.
  15. NG900 & OG9-3 Workshop
    Purchased a new wire loom and plug due to an unrelated electrical issue dealing with a car stereo installation. Cut the wires in the car behind the plug that connects to the SID. Purchased a new harness at junkyard. However, after putting it back together.. things are not working right...
  16. 9-3 Sedan, Cabrio '04+, Combi, 9-3X Workshop
    My brother borrowed my car yesterday; I've owned my 03 9-3 Linear for over a year now and NOBODY ever drove it beside me... Guess what! He managed to hit a huge pothole in the s***ty roads of Michigan and broke the lower bumper trim, lower engine cover, a small piece of the bumper and damaged...
  17. NG900 & OG9-3 Workshop
    Each time I've tried to drive this car, a 1999 9-3 sedan, after a few minutes the driver's seat lurches back to where I can barely reach the gas pedal. Naturally, I don't drive it anymore. Someone told me to pull up the "switch" and disconnect it from the "harness." The switch seems to be the...
  18. NG900 & OG9-3 Workshop
    I was looking into ways to hook up an MP3 player to the radio unit in my 2001 9-3. A couple places on the web suggest plugging an "adapter harness for mobile phone (400 109 179)" component behind the glovebox, and then soldering a toggle switch and 1/8" headphone jack to four wires off the...
1-18 of 18 Results
Top