SaabCentral Forums banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-8 of 8 Results
  1. 9-3 Sedan, Cabrio '04+, Combi, 9-3X Workshop
    A few months ago I was driving my 2006 Saab 9-3 Aero when all the sudden out of nowhere my engine started stuttering and most likely went in to limp mode (shutting of the misfiring cylinder.). I checked the codes with my reader and came up with a P0203 and P0303. Thinking it was an issue with my...
  2. 9000 Workshop
    94 9000cse with turbo stalls on start when hot. I try to keep it from stalling by rev the engine. sometimes this works. others the car still stalls out. when car is in drive. car is fine. I have replaces the fuel pump 2 times I have also used fuel injector cleaner. thanks
  3. C900 Workshop
    Hello, Been awhile since I last posted. The old girl had been running well but several months ago I lost the fuel pump, then recently it has had trouble starting. So I replaced the negative and positive battery cables this morning. It fired right up. However, about 1/4 mile from my house it...
  4. 9-5 Workshop
    Hello guys I'm new to the forum and to Saab in general, just Baught my first 2002 Saab 95 aero I have an engine code p1012 which I believe is the 1st furl injector. Can anyone help me in how to change or reach the injector. Thank you
  5. 9-3 Sedan, Cabrio '04+, Combi, 9-3X Workshop
    Hi All i have been told by a garage after a code read that i have a dead fuel injector on my saab 93 1.9 tid 06 plate. i wasnt given the code so have no idea what it was. so i checked the web and found that i can test with a multimeter and so far all 4 injectors are coming back with the same...
  6. Parts for Sale/Wanted - North America
    The engine has 120k miles on it. Exhaust valve in cylinder #2 burned. All these are for sale: water pump (no leaks, tight bearings, no wear), DIC part number TK3.2C (perfect), Fuel injectors (on rail or not, clean), Turbo (4 compressor side fins have very small chips, bearings feel worn, but...
  7. C900 Workshop
    I have a 92 900 turbo and my son said all of a sudden it quit. Don't know if this has been a on going problem. Fuel everywhere...block,turbo cooler...everwhere..Beside a bad FPR how could this much gas get everywhere? Would the computer tell the injectors they where closed if it malfunctions...
  8. 9-5 Workshop
    I have a hissing coming from a fuel injector, but I don't see any fuel spraying out. Stuck injector? If it's stuck, how do I unstick? I've run injector cleaner to no avail. I plan to change out the o rings, but I would have to order them. Does anyone have the specs for those o rings so I...
1-8 of 8 Results
Top