Hi all, I'm chasing a noise that's driving me mental. It's a simultaneous squeaking and clunking type of noise that's evident when driving slowly over bumpy roads. I can't hear it when going faster, but it might still be there, obviously. Extensive work has been done to the front and rear...

Im planning on getting the front suspension kit from eEuro this week as well as new tie rod ends for either side. Any advice from anyone about other things to look at or take care of the same time?? THKS

Hello All, I need to replace a front coil spring on my 97 NG900S with 105,000 miles. Would you replace anything else at the same time regardless of condition like shocks or mounts, etc.? Thanks

Hi All, The rubber grommet/bushing on the front right lower control arm is pretty much gone (The wheel has about 2 inches of play in it when I roll it forward/backward :o). I don't want to buy a new control arm, since the arm itself is fine. Is there anyway to buy a new bushing for it and...

So I was doing some rust repair in my wheel wells with the tires off and i noticed that my bump stops are either cracked or missing half, So I'm going to replace the front two There is nothing in the Bentley about replacement Could someone tell me how to do this, do I need to take out the...

Hi all, Has anyone tried the KYB inserts? I'm just looking to get my stock ride an handling back. Nothing too fancy. Just wondered if there's any opinions on ride, quality and part longevity. TIA, Steven

I need a new RF wheel bearing so while I'm at it I thought I should replace anything else that needs it or could need it. So let me get your opinions. 1989 900 turbo convert. with 71,000 miles. Been on the east coast and midwest most of it's life but not driven many winters. I purchased 14...