SaabCentral Forums banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-5 of 5 Results
  1. 9-3 Sedan, Cabrio '04+, Combi, 9-3X Workshop
    I replaced the front passenger side wheel hub, used a puller, took care, I thought, not to pull out the drive shaft. Everything bolted back on without anomalies, when I put it in gear, as I slowly let out the clutch, three Saab didn't move, instead I got a clicking, grinding noise from the front...
  2. 9-5 Workshop
    2008 SAAB 95 automatic I bought a drive shaft from eeuroparts DSS Axle Assembly - Front (New) SKU: 0020N and its too long to fit, the nut and thread is different, splines good. it also pulled apart on the inner boot when I was taking it out. I'll be sending it back, but what is the correct...
  3. 9-3 Sedan, Cabrio '04+, Combi, 9-3X Workshop
    Hello, So my "new" TXSC has been a pita, but at least the drive train seemed healthy. Now, after driving a few 100 km in a few weeks, I started noticing a "humming" sound or light vibration that's speed related, not rpm. It's barely noticeable, mostly between 70-110 kph. It's not felt in the...
  4. 9-5 Workshop
    i am replacing my CV joints and i got 2 new axles with the outer CV joint on one end and the tripod on the other like the photo below I have got the drive shaft out but i can not get the tripod out of the inner driver case thingy. how does one go around to getting the axle/tripod out of there...
  5. Parts for Sale/Wanted - North America
    I have a original SAAB Passanger outer driveshaft for sale, complete with a good rubber boot and tripod bearing. Asking $55 Shipped.
1-5 of 5 Results
Top