SaabCentral Forums banner

dampers

  1. How to remove strut insert nut without special tool?

    NG900 & OG9-3 Workshop
    Hi all, I'm replacing my front springs and dampers. So far so good until I got to the large flat nut that retains the damper into the strut. I tried using channel locks, but that thing is in there too tight for that. Are there any clever ways to remove that nut without special tool...
  2. Stock Suspension to Sport(y) Suspension Upgrade Recommendations

    NG900 & OG9-3 Performance, Mods & Tuning
    Hey gents, I've noticed that my suspension is due for an update and I've got a few things I'd like to find out about before dumping a pile of cash into the project. I'm not looking to make my 9-3 into an Autocrosser, race machine, show pony, or a drag racer. Just a bit better in handling so it's...
  3. Koni yellow rebound

    9-5 Workshop
    Hi, Is this how the Koni yellow suppose to rebound? (guy from KoniUSA said it is absolutely normal rebound) I need an answer urgently - rear suspension lays on the ground near me ;)
  4. Front struts/springs bad, need advice on parts!!

    9-3 Sedan, Cabrio '04+, Combi, 9-3X Workshop
    Hey all, so I was told that my driver side coil spring is dangerously bad in my '04, and my mechanic recommended I replace them as well as both the struts and the strut mounts in the front. As far as replacing those, I've seen that the Koni FSD/Vogtland spring combo works well, and I've see post...
Top