SaabCentral Forums banner

cut out

  1. Possible ECM failure?

    9-3 Sedan, Cabrio '04+, Combi, 9-3X Workshop
    Hey Guys, New to this forum so forgive me if I screw up any rules. Well here is the issue, got an '04 9-3 linear, 94000mi on it, 5-speed. Engine cut out on highway in rush hour traffic and in 96 degree heat, not fun. Started back up, ran for a couple seconds, ran rough and died. Waited a little...
  2. Rear bumper cut out

    9-3 Sedan, Cabrio '04+, Combi, 9-3X Workshop
    so guys Ive got an issue. I got a new muffler but to prepare for the dual tip i cut the bumper to fit. I cut all the way up to the dividing line in the bumper. This proves to be too high. So now theres a gap from the bumper to the muffler about 2 inches tall. any advice to make it look...
  3. 9000 CSE just cuts out

    9000 Workshop
    I have a SAAB 9000 CSE 1997 2.0 97,000miles. It is a DI red replaced about a year ago. I have a fault now diagnosed by garage as a knock sensor fault, I didnt think it even had a knock sensor! The fault is a little like a Crank Sensor fault I had on a Vectra a while back in that the car drives...
Top