SaabCentral Forums banner

crankshaft position

  1. 9-5 Workshop
    Hello everyone. I'm in the middle of replacing my timing belt on a 2000 9-5 3.0. The tensioner pulley bearing was shot and and was making a rattling noise. I ordered a new kit and was going to line up the camshafts to the respective markings on the timing belt cover before removing the belt but...
  2. 9-3 Sedan, Cabrio '04+, Combi, 9-3X Workshop
    I am attempting to locate and replace my 2003 Saab 9-3's CPS. I have hunted for it for almost 1/2 a day both online and above and below the engine. Can anyone please help me figure out where it is. I looks like a simple replacement project but I can't find it to save my life. Any help would...
  3. 9-3 Sedan, Cabrio '04+, Combi, 9-3X Workshop
    I was driving down the road, crossing some train tracks and my 2006 9-3 2.0T sedan died. Engine shut off. It would turn over, but would not start. After a group of people helped me push it to safety, I sat for a few minutes, and after about 5 minutes, I tried it again and it started. I had...
Top