SaabCentral Forums banner
clutch pedal
1-9 of 9 Results
  1. 9-3 Sedan, Cabrio '04+, Combi, 9-3X Workshop
    I was driving home from work today and noticed something was obstructing my clutch and brake pedals and found this part laying behind them. I looked underneath the dash but couldn't see where this part might have originally fit. Any ideas? The car still operates... I just hate to think I might...
  2. 9-5 Workshop
    2006 Saab 9-3. I'm having issues with the clutch pedal. Pedal is about an inch from the floor and will not depress far enough to put the car in gear. However, I can push (force) the car into first gear and then drive it while shifting gears without the use of the clutch. The clutch does not slip...
  3. NG900 & OG9-3 Workshop
    My Dad also had a Saab with a stick shift and I remember him complaining about having to constantly replace the clutch cable. So when I bought my own Saab with a stick (runs in the genes?), and the clutch cable failed, it came as no surprise. :roll: The problematic part was not the cable...
  4. 9-5 Workshop
    The clutch on my saab seems to engage really quickly and really low to the floor. I've tried searching the forum to see if anyone else has adjusted their clutch, but have only come across the ng900's. Is it possible to adjust the amount of play on the clutch on a 9-5? Or am i stuck with a...
  5. 9-3 Sedan, Cabrio '04+, Combi, 9-3X Workshop
    I own a 2005 9-3 ARC. It is experiencing these symptoms: Clutch stays on the floor There isn't any pressure in the hydraulics, i.e. if I pull the clutch up to push down, there still isn't any pressure Because the clutch won't engage I cannot shift gears Here's been the tale of diagnosing...
  6. NG900 & OG9-3 Workshop
    I have a 1998 9-3 2.3i convertible with 167k on the clock. A couple of weeks ago the clutch pedal went really soft. Called the AA and they said it was the master cylinder. There was still fluid in the reservior. Had the master cylinder replaced at my garage. First time I did a motorway run the...
  7. 9-3 Sedan, Cabrio '04+, Combi, 9-3X Workshop
    I have a 1998 9-3 2.3i convertible with 167k on the clock. A couple of weeks ago the clutch pedal went really soft. Called the AA and they said it was the master cylinder. There was still fluid in the reservior. Had the master cylinder replaced at my garage. First time I did a motorway run...
  8. NG900 & OG9-3 Workshop
    I can't believe that I fix one thing, and something else falls apart on this car. Now my clutch appears to be going. For the past few days the clutch has not been coming all the way back from the floor after shifting--I've had to pull it back (with no problem). Today I had to fight to get the...
  9. NG900 & OG9-3 Workshop
    Recently on my 1999 9-3 SE the clutch pedal doesnt return to the original position after shifting. There is about 2" of play before the pedal reaches resistance from the master cylinder. The are no problems with shifting. Do I need to replace just the pedal or the master cylinder or is it...
1-9 of 9 Results
Top