SaabCentral Forums banner

axle replacement

  1. Talladega 1997 900 CV / 2-door Convertible,

    NG900 & OG9-3 Workshop
    Hello, could someone please advise on repair or replacement of the front axle For the above cab. Am refurbishing the front end, and so far have; -Fitted new shocks -Front wheel bearings -Powered coated the front strut assembly -Replaced sway arm bushes Also planning to replace their...
  2. Questions about axles and boots

    NG900 & OG9-3 Workshop
    While I was installing rear motor mount in my '02 vert 96k I noticed a big lump of grease on the subframe directly below the passenger side inner axle boot. I can't seem to find a crack or hole in the inner boot but that may be immaterial. I have gone through the WIS to see how to R&R the axle...
  3. Saab 9-3 2005 axle replacement

    NG900 & OG9-3 Workshop
    I'm new to this forum and have no idea where to post. So if this is in the wrong spot, I'm sorry. I really need help figuring out how to properly replace my front axles. My cv joint keeps clicking and making funny noises and I decided to just replace both sides. My question is... When I take it...
  4. Axle won't go into Transmission

    9-5 Workshop
    What is the trick for getting the splined axle into the transmission? (and likewise the passenger side axle into the intermediate shaft.) I can insert the axle as far as the tip of the splines (I know this because turning the axle engages the intermediate shaft or the transmission), but cannot...
  5. Can axle replacement cause mis-alignment?

    NG900 & OG9-3 Workshop
    Is there any chance replacing an axle can put the car out of alignment? To replace the passenger side front axle on my 1994 900S, taking off the sway bar bolt and the rear control arm bolt (I wasn't able to break the front control arm bolt - the one just behind the ball joint). I used a hammer...
Top