SaabCentral Forums banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-11 of 11 Results
  1. 9-5 Workshop
    Hello, I'm driving 2003 9-5 Aero. She drives cool and everything is fine except shitty brakes. When I brake hard(hard enough to activate ABS), suddenly front RH brake locks up. Even I pull the brake pedal off, brake is keeping locked up for a sec, and then released. It seems like rear LH brake...
  2. NG900 & OG9-3 Workshop
    I bought a 2001 9-3 recently and am now trying to work through its issues. There are three codes, P0502, P0743 and P0741, so I started with P0502. As expected, the TCS, ABS and Brake lights are on in the instrument cluster. I tried swapping out the TC-ABS unit with another that I pulled from...
  3. 9-3 Sedan, Cabrio '04+, Combi, 9-3X Workshop
    just started driving a '10 9-3 6 speed. living in upstate NY the snows have started. the abs is ruining my life driving. when the road has the least bit of snow on it the abs kicks in with a series of incessant braking jerks, giving me no control as I slide by. Have read to pull fuse for abs...
  4. 9-5 Workshop
    Ok, so. 2002 9-5 wagon, and the ABS module is dying. But when it's dead, I hit over boost on the turbo (TD04HL by the by), but when the module works, I hit normal boost. I haven't had traction control for a year or so, and I always hit normal boost regardless. Has this happened to anyone else...
  5. 9-3 Sedan, Cabrio '04+, Combi, 9-3X Workshop
    Hello, I have been having an issue with my 2006 Saab 9-3 recently. The other day I was driving down the highway in a snowstorm. All of a sudden, the SID flashed "Traction Control Failure" then "Stability Control Failure" and about 30 seconds later I lost all power to the engine. The only way I...
  6. 9-3 Sedan, Cabrio '04+, Combi, 9-3X Workshop
    Looks like I might have a bad wheel bearing. Does anyone know if replacing the bad wheel bearing will solve this problem and eliminate this warning without using a Tec hII? Also wondering if I can plug a new bearing in to the sensor plug without installing it to figure out which bearing is...
  7. 9-5 Workshop
    Hi folks, My dashboard is a Christmas tree, all of the ABS/TCS warning lights are on. I replaced the "slide-out" piece on the ABS module, but the lights stayed on. Now, I have no idea whether that could be because the replacement is not the right part (it looks the same, it smells the same...
  8. 9-5 Workshop
    I have a 2000 Saab 95 2.0l 5-speed manual. I was told by the guy who I had purchaced the car from that the abs control module needed to be fixed (100$ or less). I looked on the forums and I had the same symptoms as everyone else: No speedometer on dash or HUD, no odometer readings, (ABS)...
  9. 9-3 Sedan, Cabrio '04+, Combi, 9-3X Workshop
    Hello, a while ago my wheel sensor crapped the bed and I had yet to get it serviced until now. I was having my entire suspension done and they just threw in the new sensor during the process since they would have that whole area exposed anyways. My SID was running ABS, traction, and stability...
  10. 9-3 Sedan, Cabrio '04+, Combi, 9-3X Workshop
    2003 9-3 Linear SS 114k Recently there was a snow storm and while out driving the traction control and abs failure faults came up. I didn't think much of them at the time as they were annoying me a bit anyways as the point of me driving was to have some slippery fun. Yesterday on the way into...
  11. 9-3 Sedan, Cabrio '04+, Combi, 9-3X Workshop
    Short intro-i'm a typical DIY working on my cars for as long as I can, on my 2nd saab and have done most of the typical repairs myself (cabin air, SAI valve, etc.) This problem however has me stumped! Love doing things myself but may have to resort to taking it to a shop. :( Sorry for the long...
1-11 of 11 Results
Top