SaabCentral Forums banner

shifter leather boot slacking

773 views 3 replies 3 participants last post by  snowboardin58 
#1 ·
yo alll!!!

so i ordered off a ebay a leather ****ft boot form a wrecked ng 900...

and i went to go put it on my 99 9-3 today..it went on fine over the gear knob but now i cant get it to wrap around the reverse lock part...the one you move up and down. it just doesnt close up.

is there a part that im missing?

there is four little peices at the top of the boot that are straight and seperated...am i supposed to do somthing with these?

for the time being i was pretty happy be cause it was only like ten dollers and it slid over the gear shifter alot easier then the old one came off.

but i would like to get it to wrap around the stick better. any help will be appreciated...

thanks
 
#2 ·
Cable tie needed to hold the boot onto the shaft... or you might be able to use twisted electrical (single core) cable, or maybe a hose clamp...
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top