SaabCentral Forums banner

Aquamist 2s : Does anybody have tried the 3D mapping ?

2K views 8 replies 4 participants last post by  brad 
#1 ·
I'm waiting for the aquamist 2s soon and I was thinking about 3d mapping (water quantity = f(rpm,boost)) rather than 2d (water quantity = f(rpm)) .
If somebody have any suggest to help me (about which mapping to give on output to the quantity of water from the rpm and boost pressure on input), I will appreciate.
 
#2 ·
No personal experience yet, but I do know specialists say that the water spray should start to operate before heat begins to grow in the cylinder head.
So, it's a good idea to program the system to start spraying from relatively low boost level - this prevents heat build-up in the head, and will give more margin for increased boost. Then, at the top end, the Aquamist guys recommend as much water as the engine can take - that is, the maximum water output without losing engine power. too much water can actually lead to lower output.
It'll require some trying and testing, I figure, but in the end you should be very pleased about the system's performance.
 
#4 ·
Do you intend to use the MAF meter for the 0-5 volt signal or add a map sensor? It has been found that working with the 3000rpm portion first and working both directions from there is the quickest way to tune. Adjust for best performance. When it is correct use rate of gain to adjust for seasonal weather changes if needed.
 
#5 ·
Peak combustion chamber temperatures occur at peak torque, hence maximum flow required at this point. The water flow should then be tailed off after this point, though allowance needs to be made for a leaness induced high temps (especially Bosch 2.2).
 
#6 ·
Brad, I will use the map sensor.

NB: I just receive from DEMON TWEEKS the kit yesterday and IT WAS EMPTY !!!!! Only the pump was in the package !!!! no injector, no mf2 driver...nothing ! I'm really really disapointed. I do not understand how they can send me in France a system that I paid 600GBP with an nearly empty kit.
I'm really beside myself.
 
#7 ·
Was there a kit number on the box 1s, 2c or 2s. Maybe it was just mis picked. On the invoice what part number did they charge you for. 806-002, 806-008 05 806-005? A lot of questions I know but maybe we can find and answer. Were you getting a MAP sensor from them?
Brad
 
#8 ·
Thank you brad for your help. Sometimes I think that I did not choose the right supplier...
Anyway, they charge me the part number 806-005. Yesterday, I send back the box to demon-tweeks for an exchange BUT they told me that I only will receive a new kit as soon as they found why the first kit was not complete. I hope that they would find fast.
For the question of MAP sensor, I didn't order the sensor yet. I'm waiting for the kit first...Happy face !
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top