Checking Lucas recorded faults [Archive] - SaabCentral Forums

: Checking Lucas recorded faults


niko
02-06-02, 05:22 AM
Thanks to Marko, we have on this site a Lucas faultcode list. But I do not understand which "yellow/white wire from 3-pin connector" to connect via a switch to ground to begin the test procedure.
Can somebody help me ?

Fred
02-06-02, 01:29 PM
Its a single loose connector on the end of a 30cm length of wire covered by a piece of black plastic sleeving. The book says 3 pin connector, but I've only ever seen a single pin.
It's tucked down between the inner wing panel and the fresh air inlet. Same sort of area as the in line connector for the lambda sensor.
There's also a test connector for ECU under the rear seat - but I don't know what its for, goes to different ecu pins to the code connector.
Fred

niko
02-06-02, 11:43 PM
Ok. I will check this evening.
Thanks a lot.