7th May 2010, 02:44 PM
Does anyone have an ECU connector or part of the ECU harness with the connector on it that they can part with?
I need to fabricate a power connector to flash/tune an ECU for a 1998 2L Turbo with a T5 ECU.
10th May 2010, 04:29 PM
You can make your own power cable with mini-alligator clips, wire and wire nuts. You just need to be careful when you connect the alligator clips - make sure you pin them out correctly and make sure you don't short across pins. Provide 15-18v DC.
Another way would be to leave the ECU in the car and tune via the SFI connector or any other access point in the ecu harness. I understand this is possible from the CD connector.
10th May 2010, 05:44 PM
You might also call up a junkyard. They're big fans of chopping off wiring harnesses instead of unplugging things, so someone would probably be willing to cut one off to sell.
11th May 2010, 10:42 AM
Here are the numbers for a new one.
Article : Connector housing 70-pin, female
PartNo : 4176616
Usage : TWICE, TRIONIC
Order Quantity : 1
Article : Cable terminal (Small)
PartNo : 4115499
Usage : AREA 0, 5-1, 0 MM2, NLS-USE 12790414
Order Quantity : 2
Article : Cable terminal (Large)
PartNo : 9120957
Usage : AREA 0, 5-1, 0 MM2, NLS-USE 12789796
Order Quantity : 4