SaabCentral Forums banner

Tranny-Won't go on?

520 views 4 replies 3 participants last post by  899000turbo 
#1 ·
Now its oppsite, my i took my tranny off with a bit off a struggle but putting it back on seems a little bit worst.
I'm sure i have my clutch disk centered, and althought i thaught i was sure with the teeth lining up, if they havent im sure i have spun the fly in a 360 pushing and noding to try.

to anyone who has had the problem with getting it back on how did you get it fixed?
im sure its lining at the shaft and its on the top stud so any ideas?
 
#4 ·
I can comiserate - there is a bit of a knack to getting things lined up
1) it helps if - using a dremel etc.. chamfer the lead in,s on the splines of the gearbox and the intermediate drive shaft - it,s a nice to do
2) use snug fitting long bolts on the two mating dowel holes to guide you in
3) find the balance point on the box or else you,ll be fighting with it
4) adjust the block height / gearbox so you mate up parrallel to each other
5) use the bolts to pull it in

It is an knack thing nad it can be a pain until it seems to just slip in
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top