SaabCentral Forums banner

AS2 Line Level Output in Volts - setting gain

610 views 0 replies 1 participant last post by  zool0 
#1 ·
Hi,

I have installed an aftermarket amplifier and a 10 inch subwoofer into my 9-5. I have tapped the front pre-outs from the input side to the stock AS2 amplifier. Thanks stipud for the advice on the forum, it was a very simple job.

I've finally received my subwoofer enclosure, so I just have to install the sub into the enclosure, and wire up the speaker wires. I've already tested that the amp turns on and it is working.:D

Does anyone know what the max voltage is on the pre-out? I'd like to set the gain on the amplifier, and the gain dial shows the input level of the pre-outs from 2V to 0.2V. I don't desire any clipping, so if the pre-out level is 0.2V, I'd set the gain lower than that anyway. I just want to know what the absolute max is.:)

Thanks
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top